Global Journal of Environmental Science and Management
Volume:2 Issue: 2, Spring 2016

During the last years, several exceedances of PM10 and benzo(a)pyrene limit values exceedances were recorded in Taranto, a city in southern Italy included in so-called areas at high risk of environmental crisis because of the presence of a heavy industrial district including the largest steel factory in Europe. A study of these critical pollution events showed a close correlation with the wind coming from the industrial site to the adjacent urban area. During 2011, at monitoring sites closes to the industrial area, at least the 65% of PM10 exceedances were related to wind day conditions (characterized by at least 3 consecutive hours of wind coming from 270-360±2deg with an associated speed higher than 7 m/s). For this reason, in 2012 an integrated environmental permit and a regional air quality plan were enacted to reduce pollutant emissions from industrial plants. A study of PM10 levels registered during windy days was performed during critical episodes of pollution highlighting that the difference between windy days and no windy days’ concentrations reduces from 2012 to 2014 in industrial site. False negative events (verified ex-post by observed meteorological data) not identified by the forecast model - did not show a significant influence on PM concentration: PM10 values were comparable and sometimes lower than windy days levels. It is reasonable that the new scenario with a relevant reduction emissions form Ilva plant reduced the pollutants contribution from industrial area, contributing to PM10 levels decrease, also in false negative events.

The isolated fungi species of different kinds from chromium contaminated soil sites located in Nagalkeni, Chennai were used for reducing chromium(VI) in a tannery industry wastewater of Nagalkeni, Chennai. The experiments were conducted to know biosorption potential of isolated fungi species for removing chromium(VI) in a tannery industry wastewater against the different pH, fungi biomass and chromium(VI) concentration (dilution ratio). The results of this study indicated that the order of maximum removal of chromium(VI) by an isolated fungi species at an optimum pH of 3, fungi biomass of 4g andan initial chromium(VI) concentration of 18.125 mg/L (dilution ratio 4)is A. niger > A. flavus > A. fumigatus > A. nidulans > A. heteromorphus > A. foetidus > A. viridinutans. This study found that the maximum removal of chromium(VI) was achieved by Aspergillus niger (96.3 %) than other fungi species at chromium(VI) concentration of 18.125 mg/Lin a tannery industry wastewater. The chromium removal from tannery industry wastewater was validated by checking chromium removal in an aqueous solution and by checking the removal efficiency of other parameters in a tannery industry wastewater using same isolated A. niger. Biosorption model was proposed to simulate the experimental condition for removing chromium(VI) in a tannery industry wastewater by all isolated fungi species. The R2 and values of the proposed model predicted that the proposed biosorption model is very much useful for predicting the trend of reduction potential of chromium(VI) in a tannery industry wastewater by all isolated fungi species. This study suggested that one could select the type of fungi species, ion concentration level, selection of treatment period, quantity of biomass to be used, and pH level of the medium, to achieve the highest reduction of any toxic metals from any contaminated water, wastewater and soil environment.

Erosion plots were selected for characterizing the effects of main natural factors on runoff and soil loss in a semi-arid region. These erosion plots with an area of 40 m2 are located in the Kakhk experimental watershed in Gonabad County of Khorasan-e Razave Province in the north-eastern Iran. Data acquired from 2008 to 2015 include slope, aspect, soil texture and land covers (canopy and litter) factors that were selected as main natural factors and it was tried to determine the effects of these factors on runoff and soil loss amount. In the next stage, it was focused on evaluation of the effects of land covers on runoff generation and soil loss in more details. For this purpose, in each class of the mentioned factors, the relationship between land covers and runoff and soil loss was analysed. The maximum of runoff and soil loss were occurred at E site with the amount of 15.6 mm and 140 g/m2 respectively. Results showed that soil loss and runoff have decreased where the amounts of land covers have increased, and the line gradient is steeper for soil loss reduction than runoff generation. The result especially characterized the role of land covers on soil loss. Based on these results land covers have a significant effect on soil loss but this effect is mostly highlighted in the highest and lowest conditions of erosion potential, rather than the medium erosion potential condition. Furthermore, in each plot and event, a dominant factor determines the quantity of the effect of land cover on runoff and soil loss.

Heavy metals and dyes are major contributors in contamination of water streams. These contaminants enter into our eco- system, thus posing a significant threat to public health, ecological equilibrium and environment. Thus a combined discharge of these contaminants results in water pollution with high chemical oxygen demand, biological oxygen demand, color, particulate matter, suspended particles and odor. The mounting pollution of the water bodies has attracted attention of the researchers towards the development of novel techniques and materials for water pollution. The paper describes the use of such a material Parthenium hysterophorus, a weed, explored for water purification. The potential of the weed has been tested for several heavy metals and dyes as described in this paper. As per literature the weed is capable of showing adsorption tendency up to 90% in certain cases for some heavy metals and dyes. Powdered weed, activated carbon, ash etc. of Parthenium have been employed for the removal process.

Presence of toxic metals in agricultural soils can impose adverse health impact on consumers. The main purpose of this study was to determine spatial distribution of elements Fe, Sb, Mn in agriculture soils and crops of Hamedan Province in Iran. Soil samples (0-20 cm depth) were collected from an area of 2831 km2. Iron, Antimony and Manganese in samples of soil and agricultural crops were extracted and their amount was determined using atomic absorption spectrometer. The spatial distribution map of the studied elements was developed using Kriging method. The main concentration of Fe, Sb and Mn in the soil of the study area is about 3.8%, 2.5 and 403 mg/kg, respectively. According to chemical partitioning studies, the anthropogenic share of Fe, Sb and Mn is about 28.51%, 34.83% and 30.35%, respectively. Results of comparison of heavy metals pollution intensity in the agricultural soil with geo-accumulation index and also pollution index, illustrated that iron and manganese are classified in the Non-polluted class and antimony is in the moderately polluted class. Analysis of zoning map of pollution index showed that Fe, Sb and Mn are of geological sources. In fact, these metals are naturally found in soil. However, anthropogenic activities have led to more accumulation of these metals in the soil. The obtained health risk for metals in agricultural crops is indicative of safe value for consumers.

Organic fraction of solid waste, which upon degradation produces foul smell and generates pathogens, if not properly managed. Composting is not a method of waste disposal but it is a method of waste recycling and used for agricultural purposes. An integrated approach of composting methodology was tested for municipal solid waste management. Solid waste first was composted and after 22 days, was further processed by vermicomposting. Samples were routinely taken for analysis of carbon, nitrogen, moisture content, pH and temperature to determine the quality of composting. Decrease in moisture content to 32.1 %, relative decrease in carbon and nitrogen content were also observed. Among the different types of treatment, municipal solid waste + activated sludge integration showed promising results, followed by vermicomposting municipal solid waste + activated sludge combination, compared to the combinations of dried activated sludge, municipal solid waste + activated sludge semisolid and municipal solid waste + sewage water. Thus, windrow composting followed by vermicomposting gave a better result than other methods. Thus this method would serve as a potential alternative for solid waste management.

A risk assessment study was conducted to predict the expected hazardous influence on the ecosystem resulted from urbanization and industrialization activities at Helwan area, Egypt. To achieve these goals, soils, plants and water samples were collected from Helwan area, and their total concentrations of inorganic contaminants (Cd, Cr, Co, Cu, Fe, Mn, Ni, Pb, and Zn) and organic pollutants; such as Phenol and hydrocarbons were measured. The obtained results showed that, the concentrations of organic contaminants in water streams and surrounding soils recorded high concentration values than the permissible limits, while inorganic elements were within the safe limits for irrigation. In addition, soils irrigated with the effluents of industrial units recorded high values of inorganic and organic contaminants. Consequently, the levels of these contaminants were high in plant tissues grown thereon; especially the edible parts. Risk assessment based on available Predicted No Effect Concentration values for the aquatic and terrestrial environment was performed. Inorganic elements were expected to cause serious hazard problems for both aquatic organisms and soil microorganisms. The impact of these pollutants on human health was calculated using daily metals intake of inorganic metals via consumption of edible plants. Hazard index values proved that concentrations of Cr may cause serious hazard problems for humans in this area; especially, children.

Landfill leachates are potential threats for environmental degradation. This study was conducted to determine the leachate quality, to identify the dominant pollutants and to evaluate the leachate pollution potential of an active and closed dumping ground of an uncontrolled municipal solid waste landfill site in Kolkata, India using leachate pollution index. The results of the physico-chemical and biological analyses of leachate indicated that landfill site was in its methanogenic phase. Among the analysed leachate pollutants, TDS, BOD5, COD, TKN, NH3-N, Cl¯, TCB, Pb, and Hg surpassed the leachate discharge standards for inland surface water as specified by the municipal solid waste (Management and Handling) Rules, 2013 for both the dumping grounds. Moreover the concentrations of total Cr and Zn also exceeded the leachate disposal standards for the active dumping ground. The leachate pollution potentialities of both the active and closed dumping grounds were comparable as the overall LPI obtained 34.02 and 31.80 respectively. The overall LPI, LPI organic (LPIor), LPI inorganic (LPIin) and LPI heavy metals (LPIhm) of both the dumping grounds largely exceeded the LPI and sub-LPI values for treated leachate before disposal to the inland surface water. In terms of the individual pollution rating, total coliform bacteria, TKN, NH3-N and Hg were identified as the dominant pollutants and major contributing factors for the leachate pollution potential.

The carrying capacity is well identified tool to manage problems due to uncontrolled tourism for any destination. This report highlights the carrying capacity estimation of Kerwa tourism area, Bhopal, India. The methodology used in this report is a new two-tier mechanism of impact analysis using index numbers derived from a survey of 123 stakeholders. From this the individual component impact analysis and the total carrying capacity of the area is computed in order to state the insight of the total carrying capacity left for the tourism activities in Kerwa tourism area. It is calculated from, the results so obtained, that the Kerwa catchment area falls in “very low impact category” and hence in a healthy state of the artwork in terms of total carrying capacity. The study conveys the current need in the destination management and tourism development as a road map for the destination managers for implementing sustainable tourism.

This study recommends a GIS-based (Geographic Information Systems) and multi-criteria evaluation for site selection of gas power plant in Natanz City of Iran. The multi-criteria decision framework integrates legal requirements and physical constraints related to environmental and economic concerns. It also builds a hierarchy model for gas power plant suitability. The methodologies used for site selection include analytic hierarchy process (AHP), fuzzy set theory and weighted linear combination. The AHP (analytic hierarchy process) is a multi-criteria approach which is used to establish the relative importance of criteria. The AHP makes pair-wise comparisons of relative importance between hierarchy elements categorized by environmental decision criteria. In the next step, the fuzzy set theory is used to standardize criteria through different fuzzy membership functions and fuzzy layers are formed by using fuzzy operators in ArcGIS environment. Subsequently, they are categorized into 6 classes using Reclassify Function. Weighted linear combination is used to combine the criteria layers. Finally, the two approaches are analyzed in order to locate the most suitable site to establish a gas power plant. According to the results, using GAMMA fuzzy operator is considered suitable for this site selection.