Pollution
Volume:1 Issue: 2, Spring 2015

Agricultural waste fibers have been found to be suitable as reinforcement in cement-based composites, but studies on oil palm fiber as reinforcement in gypsum-cement wall panels are scarce. A mixture of two equal weights of gypsum and cement, with water-binder ratios of 0.45 and 0.55 were prepared. In each mix a varying percentage of fiber contents of 2%, 3% and 4% by weight of the binders were added. The properties of the wall panels were determined from cast specimen sizes of 100x 100 x 40 mm for density, moisture content and water absorption; 160 x 40 x 40mm for compressive strength, and 650 x 100 x 25 mm for bending strength. The specimens were cured in water and tested at ages of 3, 7, 14, 21, and 28 days. The results of density of the wall panels were within the range of 1634–1742 kg/m3, while the moisture content range of 3.30–8.45%, and the water absorption varies from 5 to 12%. The compressive strengths were found within the range of 1.92–5.20N/mm2 and, generally, decreases with the increasing percentage of fiber contents, but increased with curing age. The bending strength falls within the range of 2.04–4.13 N/mm2that increases with curing age and slightly increased with fiber content. It is concluded that oil palm fiber reinforced gypsum-cement wall panels are suitable as wall element.

Noise is one of the main parameters to be considered to achieve a healthy indoor ambience in ferries. Therefore, the noise standards need to be more specialized and specifically based on real sampled data and case studies. In the present research, the noise levels in a ship, under different working conditions, were sampled and compared with those specified in the new and old standards. An initial study showed two main noise sources- clients and main engine- that influence other indoor environments, reducing the quality of life on board. The real-time data revealed that the maximum noise level limits set by the International Maritime Organization (IMO) in the older Resolution A.468 (XII) was mostly respected, except in areas where maintenance of the noise level was difficult, owing to the continuous influx of people, especially at the time of boarding and disembarking of the passengers and at the food self-service areas. In this sense, under the new Resolution MSC.337 (91), the maximum noise level allowed in the accommodation has been reduced by 5 dB (A), but this environment does not meet the standard. More results show that future standards must not only consider the noise level in a working place and add another variable, such as, the number of working hours, to obtain a representative equivalent energy, and they must also consider that a simple modification of this standard implies a redesign of most of the indoor ambiences onboard.

A student-centric research education program with the active participation of undergraduate students is initiated. The aim is to imbibe ―responsible citizenship behavior‖ in them so that each member becomes conscious and well trained to take up environmental-related issues and challenges for long-term sustainability of the ecosystem. In this work, we report spectrophotometer-based estimation of hexavalent chromium (57-268 gL-1) and lead (34–158 gL-1) concentrations in different surface waters and groundwater samples in and around the city of Hyderabad, India. Our results indicate that the studied surface water bodies and aquifers are contaminated to variable degrees and pose a serious threat to the ecosystem. In view of low geochemical baseline values for chromium and lead, the origin of heavy metal pollution is inferred to be anthropogenic, mainly originating from industrial effluents. The toxicological data are integrated with health data for risk assessment and impending health hazard. Finally, the novelty of this student-centric research program is highlighted.

Rajasthan is one of the main mineral potential state of India. During the last 30 years it has witnessed enormous expansion of mining industries, but mining of most of the minor minerals coupled with changing climate has posed serious problems to the environmental fabric in the state, apart from base metal beneficiation plants. Groundwater is also being polluted day-by-day by effluents generated from mineral wastes and beneficiation processes in the vicinity of mining sites such as Khetri. Pollutant concentrations were measured in groundwater at the vicinity of Khetri copper mining project, Rajasthan to investigate the influence of copper mining on environment. Pollutant concentrations in groundwater were investigated. Copper metal concentration in water samples were found above the maximum desirable limit in two sources: G4 and G5, due to washing away of mineral with water. Mining industry has deteriorated quality of groundwater resources in the state of Rajasthan, and these industries are becoming centers of pollution sources which need timely actions at government level so that natural resources such as groundwater can be protected.

To determine the suitable indices for vegetation cover and production assessment based on the remote sensing data, simultaneous digital data with field data belonging to the spring rangeland of the Semirom-Isfahan province were analyzed. During two years of monitoring the annual, grass, forb, and shrub vegetation cover and the total production data from 86 were collected. The Global Positioning System (GPS) was used to measure the coordinates of plots and transects. Geometric correction and histogram equalization were applied in image processing, and image digital numbers were converted to reflectance numbers. In the next stage, all vegetation indices were calculated from the Advanced Wide Field Sensor (AWiFS) image data and compared with the vegetation cover estimates, at monitoring points, made during field assessments. A linear regression model was used to select suitable vegetation indices. The results showed that there were significant relationships between the satellite data and the vegetative characteristics. Among the indices, the Normalized Difference Vegetation Index (NDVI) consistently showed significant relationships with the vegetation cover. The estimation of the vegetation cover with the NDVI vegetation index was more accurately predicted within rangeland systems. Using the produced model from the NDVI index vegetation crown cover, percentage maps were produced in three class percentages for each image. Generally introduced indices provided accurate quantitative estimation of the parameters. Therefore, it was possible to estimate cover and production as important factors for range monitoring using the AWiFS data. The Remote sensing data and the Geographic Information System are the most effective tools in natural resource management.

This comprehensive work explores the research performed in optimization of the collection bin and in recycle bin location-allocation issues in solid waste management. Although the collection phase of solid waste management accounts for a significant proportion of the municipal budget, it has attracted only limited attention of the researchers. Optimization of the collection bin and recycle bin location- allocation problems in solid waste management can be advantageous with respect to bin access to every individual person of municipality, reduction in the numbers of open dumping yards, considerable profit if the recycled products are properly processed, and as an effort toward sustainable and green world. Hence, the topic of interest should be pursued, especially in developing countries, to enable development of a cost-efficient and sustainable solid waste management system.

Phytoremediation is an eco-friendly method for removal of pollutants, which can be relied upon as a sustainable technology, if implemented under optimum conditions of plant growth. The effectiveness of water hyacinth, a topical weed, for the removal of Zinc (Zn) and Chromium (Cr) ions from aqueous solutions has been presented in this article. The potential of this plant in removing metals by phytoremediation was explored under various environmental factors such as pH, salinity, metal concentrations, available nutrients, and so on. The efficiency of metal removal was observed by varying the different parameters. It was found that the maximum removal of metals occurred at a neutral pH, low amount of salinity, lower metal ion concentrations, and lack of nutrients. The stress induced in a plant by metal absorption was visible from the health and growth pattern of the plants. The stress on water hyacinth due to metals was also assessed, by observing the changes in its chlorophyll and protein content.

The impact assessment method seeks to bring about a more ecologically, socio-culturally and economically sustainable and equitable environment. Determining the main factors affecting the attitudes of stakeholders is crucial for understanding the impacts of development plans. This approach helps planners and decision makers to identify the values and traits of stakeholders and accelerate the diffusion of innovations through designing proper incentives and removing available obstacles. The purpose of this study is to examine factors affecting laser land levelling project impacts in Fars Province, Iran. The sample included 285 farmers who were selected using multi-stage random sampling. The validity and reliability of the questionnaire were measured and revisions were made to improve measurement scales. The results of structural equation modelling indicated that reduction in water consumption was the most important variable which affected the recognition of impacts among laser land levelling adopters. Furthermore, laser land levelling impacts as dependent variables were influenced by the direct effect of the duration of adoption, attitude towards water and soil conservation, need perception and attitude toward prior projects. Based on the results, practical recommendations have been presented.

Improving the resource use efficiency in agro- ecosystems is an important factor for reducing environmental pollution. To evaluate phosphorus (P) efficiency and balance indicators, research was conducted in wheat and saffron production systems in the Qaenat region (South Khorasan Province, Iran) during 2011 and 2012, based on the method of the Organization for Economic Co-operation and Development (OECD). The required information about wheat and saffron cultivation was collected via questionnaires and the required coefficients were obtained from various literatures. The results showed that the phosphorus efficiency and balance indicators were significantly different between distinct districts only in the case of wheat crops. The highest P efficiencies of wheat and saffron farms were 7.21% and 2.93%, respectively. Additionally, P efficiency and balance indicators showed a significant difference between both crops in some districts, so that wheat had higher P efficiency than saffron, which was mainly because of the different amounts of animal manure applied to these crops. There was no significant difference between the different ages of saffron farms for P efficiency and balance. Furthermore, there was a significant negative correlation between P efficiency and balance indicators. It would appear that there are many opportunities for improving the efficiency of P and to prevent environmental pollution through the optimization of management decisions.

Iran has mountainous landscapes and half of its surface is occupied by highlands. Moreover, Iran is an arid country and deserts are located at lower altitudes. Most metropolitan areas are positioned in mid-altitudes between mountain and desert. Cities grow upwardly toward the highlands under pressures of urbanization and desertification. Foothill ecotones are a zone between upland mountains and midland plains. Upwardly sprawl of urban centers has transformed the structures and functions of these ecologically strategic belts. In this article, we analyzed the transformational trend of the ecotonal zone in the southern slopes of the central Elburz (Tehran-Karaj urban region). Landsat 7 ETM+ (2000) and 8 OLI (2013) are used to monitor spatial and temporal variability of landscape metrics. The land covers are grouped into four classes: vegetation cover, open space, built area, and water body. Seven landscape metrics are used including: NP, CAP, MPS, AW-MPS, MNND, PARA, and TE. Our results indicate that NP, AW-MPS, TE, and PARA increased whereas CAP and MPS decreased. These results are a sign of the fragmentation process across the ecotonal strip.