Optimization of Scan and Reconstruction Parameters for Renal Artery CT Angiography with Iterative Reconstruction at Low kVp Compared with Filtered Back Projection at 120 kVp Acquisition

As cross-sectional images expanded in clinical practice, the number of renal lesions discovered incidentally has been increasing. CT protocols for renal mass evaluation may include pre- and post-contrast phase. However, a major concern with respect to those multiphase techniques is often the radiation dose. One further critical issue is how to minimize the radiation dose while image quality is optimized in routine daily clinical practice.
To evaluate the image quality and radiation dose of renal artery CT angiography (CTA) with optimal sinogram affirmed iterative reconstruction (SAFIRE) strength level at 80 kVp for optimizing the scan and reconstruction parameters of renal artery CTA, in comparison to 120 kVp acquisition with filtered back projection (FBP).
Patients and Sixty consecutive patients were classified into three groups prospectively in this study: 1) 80 kVp group (n = 30) with FBP and 2) 80 kVp group with SAFIRE (S4) and 3) 120 kV group (n = 30) with FBP. CT values and noise were measured, contrast-to-noise ratio (CNR) and signal-to-noise ratio (SNR) of the renal artery CTA were calculated for quantitative assessment. Subjective image quality was evaluated by two experienced abdominal radiologists with a five-point scale in a blinded and randomized setting for qualitative assessment. Volume CT dose index (CTDIvol) and size-specific dose estimate (SSDE) were calculated and estimated for each subject presented in this study.
As for quantitative assessment, CNR, SNR and CT values of renal artery in 80kVp group with SAFIRE strength levels or FBP were higher than those of 120 kVp group with FBP (all Ps In patients with BMI lower than 28 kg/m2, renal artery CTA at 80 kVp with SAFIRE is feasible and can provide satisfactory images for clinical applications. This method also provides reduction in radiation dose. SAFIRE strength level 4 is recommended for reconstructing renal artery CTA.