به جمع مشترکان مگیران بپیوندید!

تنها با پرداخت 70 هزارتومان حق اشتراک سالانه به متن مقالات دسترسی داشته باشید و 100 مقاله را بدون هزینه دیگری دریافت کنید.

برای پرداخت حق اشتراک اگر عضو هستید وارد شوید در غیر این صورت حساب کاربری جدید ایجاد کنید

عضویت
فهرست مطالب نویسنده:

a. r. alizadeh

  • علیرضا علیزاده جاجرم، حمیدرضا گشایشی*، کاظم بشیرنژاد، ایمان زحمتکش

    در این پژوهش عملکرد یک لوله گرمایی نوسانی سه بعدی در زوایای مختلف استقرار از صفر تا 90 درجه با سیال عامل آب مقطر و نانوسیال به صورت تجربی مورد بررسی و مقایسه قرار گرفته است. نانوسیال Fe3O4  با کسر جرمی 1/0 درصد تهیه و برای پایداری آن از سورفکتانت تترامتیل آمونیوم هیدرواکسید استفاده شد. ابتدا آزمایشات در شارهای گرمای ورودی مختلف (30 تا 300 وات) و نسبت های پرشدگی 50 و 60 درصد انجام و نسبت پرشدگی بهینه (50%) مشخص گردید. سپس با این مقدار، عملکرد حرارتی لوله گرمایی نوسانی در زوایای مختلف بدون حضور و همچنین با اعمال میدان مغناطیسی ارزیابی شد. نتایج آزمایشات نشان داد که نانوذرات Fe3O4 می توانند عملکرد گرمایی دستگاه را بهبود بخشند. همچنین  مشخص شد که نسبت پرشدگی بهینه برای این دستگاه 50 درصد می باشد. با افزایش شار گرمای ورودی، مقاومت گرمایی لوله گرمایی کاهش می یابد. علاوه بر این نتایج نشان داد که زاویه شیب لوله گرمایی تاثیر قابل توجهی بر عملکرد لوله گرمایی دارد. در حالت افقی عملکرد دستگاه اصلا مناسب نبود، اما با اعمال میدان مغناطیسی، دستگاه می تواند به کار خود ادامه دهد.

    کلید واژگان: لوله گرمایی نوسانی سه بعدی، نسبت پرشدگی، زاویه استقرار، نانوسیال مغناطیسی، میدان مغناطیسی، مقاومت گرمایی
    A. R. Alizadeh, H. R. Goshayeshi, K. Bashirnezhad, I. Zahmatkesh

    In this research, the performance of a three-dimensional oscillating heat pipe in different inclination angles from 0 to 90 degrees with distilled water and ferrofluid as operating fluid has been studied and compared experimentally. Fe3O4 ferrofluid was prepared with a mass fraction of 0.1% and tetramethyl ammonium hydroxide surfactant was used for its stability. First Experiments were performed at different input heat input fluxes (30 to 300 watts) and in filling ratios if 50 and 60%, and the optimal filling ratio (50%) was determined. Then with this value, the thermal performance of the oscillating heat pipe was evaluated at different angles without presence and also by applying a magnetic field. The experimental results showed that Fe3O4 nanoparticles could improve the thermal performance of the device. It was also found that the optimal filling ratio for this device is 50%. As the inlet heat flux increases, the thermal resistance of the OHP decreases. In addition, the results showed that the inclination angle of the heat pipe has a significant effect on the performance of the OHP. In horizontal mode, the device did not work at all, but by applying a magnetic field, the device can continue to operate.

    Keywords: 3-D oscillating heat pipe, filling ratio, inclination angle, ferrofluid, magnetic field, thermal resistance
  • M. Owji, F. Modarressi, B. Geramizadeh, A. Borhani Haghighi, Ar Alizadeh, T. Heidari
    Background
    Skeletal muscle biopsy is important for the diagnosis of motor unit disorders, systemic diseases and metabolic disorders. In some cases, routine histopathologic methods are not conclusive and histochemistry, immunohistochemistry and even an electron microscopic study are required. In this study, we describe our experience in the diagnosis of myopathies, considering all of the above-mentioned methods.
    Methods
    During a period of 18 months, 43 specimens of patients with the impression of myopathy were submitted to the Pathology Department and were evaluated with H & E and histochemical stainings (PAS, Oil red O, ATPase, NADH-TR, Gomori Trichrome), immunohistochemistry (IHC) for dystrophin and electron microscopy. Three specimens were excluded from the study because there were only adipose tissues and no adequate muscle was present for evaluation.
    Results
    Twenty three (57.5%) males and 17 (42.5%) females with a mean age of 34 years were evaluated. The results were as follows: Becker''s muscular dystrophy (5 cases, 12.5%), Duchenne''s muscular dystrophy (3 cases,7.5%), fascioscapulohumeral dystrophy (3 cases, 7.5%), limb girdle dystrophy (2 cases, 5%), polymyositis (6 cases, 15%), dermatomyositis (2 cases 5%), McArdle''s disease (1 case, 2.5%), hypothyroidism myopathy (1 case, 2.5%), type 2 atrophy secondary to drugs and systemic diseases (2 cases 12.5%), congenital myopathy (2 cases 5%), McArdle (1 case 2.5%), unclassified myopathy (2 cases, 5%), and normal muscle biopsy (8 cases, 20%). Although a genetic study was not available to confirm the diagnosis of cases such as fascioscapulohumeral myopathy, the diagnosis was made after putting all of the findings together including clinical presentation, family history, NCV, EMG, etc.
    Conclusion
    In the cases with no definite diagnosis by the histology, histochemistry and IHC, we should perform an EM study to find out the distinct ultra-structural changes which can be diagnostic for some muscle disorders. EM study in conjunction with light microscopy of muscle biopsy could be very helpful in establishing the diagnosis of some types of myopathies.
بدانید!
  • در این صفحه نام مورد نظر در اسامی نویسندگان مقالات جستجو می‌شود. ممکن است نتایج شامل مطالب نویسندگان هم نام و حتی در رشته‌های مختلف باشد.
  • همه مقالات ترجمه فارسی یا انگلیسی ندارند پس ممکن است مقالاتی باشند که نام نویسنده مورد نظر شما به صورت معادل فارسی یا انگلیسی آن درج شده باشد. در صفحه جستجوی پیشرفته می‌توانید همزمان نام فارسی و انگلیسی نویسنده را درج نمایید.
  • در صورتی که می‌خواهید جستجو را با شرایط متفاوت تکرار کنید به صفحه جستجوی پیشرفته مطالب نشریات مراجعه کنید.
درخواست پشتیبانی - گزارش اشکال