foad shahabian

The aim of this study was to compare flexural strength of specimens processed by conventional and injection-molding techniques. Conventional pressure-packed PMMA was used for conventional pressure-packed and injection-molded PMMA was used for injection-molding techniques. After processing, 15 specimens were stored in distilled water at room temperature until measured. Three-point flexural strength test was carried out. Statistical analysis was carried out by SPSS using t-test.

Acrylic resin denture bases undergo dimensional changes during polymerization. Injection molding techniques are reported to reduce these changes and thereby improve physical properties of denture bases. The aim of this study was to compare dimensional changes of specimens processed by conventional and injection-molding techniques. SR-Ivocap Triplex Hot resin was used for conventional pressure-packed and SR-Ivocap High Impact was used for injection-molding techniques. After processing, all the specimens were stored in distilled water at room temperature until measured. For dimensional accuracy evaluation, measurements were recorded at 24-hour, 48-hour and 12-day intervals using a digital caliper with an accuracy of 0.01 mm. Statistical analysis was carried out by SPSS (SPSS Inc., Chicago, IL, USA) using t-test and repeated-measures ANOVA. Statistical significance was defined at P<0.05. After each water storage period, the acrylic specimens produced by injection exhibited less dimensional changes compared to those produced by the conventional technique. Curing shrinkage was compensated by water sorption with an increase in water storage time decreasing dimensional changes. Within the limitations of this study, dimensional changes of acrylic resin specimens were influenced by the molding technique used and SR-Ivocap injection procedure exhibited higher dimensional accuracy compared to conventional molding.

The aim of this study was to evaluate the effect of bridge orientation in casting machine on castability and quality of base metal castings. Three groups of patterns with different direction and lengths in casting machine were casted and then studied qualitatively and quantitatively using mean and standard deviation in table of frequency. Larger nodules and porosities were on the joints of sprue in horizontal specimens (P=0.01 and 0.048, respectively). There was no significant difference in castability between 3-, 5- and 6-unit bridges in relation to their direction in casting machine (P=0.5). An increase in bridge length led to more variation in length and width. The position of bridges also played an important role in the length variation in bridges. The direction of bridges had no effect on base metal castability but a vertical position resulted in a better casting quality and an increase in length of the bridges caused more defects in castings.