Copper Cone Shell production Using Electroforming Process and Investigating Parameters Effect on the Process by the use of Numerical Simulation
Author(s):
Article Type:
Research/Original Article (دارای رتبه معتبر)
Abstract:
The purpose of this study is to demonstrate the advantages of computer simulation and parametric studies in improving the copper electroforming process. For this purpose, the finite element model for a cone geometry was prepared using the Comsol software, and the effect of key parameters including applied current density, solution electrical conductivity, electrode spacing, and anode length, on the thickness uniformity. In order to validate the model, a conical shell was produced in the laboratory by electroforming method, and the thickness distribution was compared with the simulation results. The comparison of the results showed that using the tertiary current distribution method to simulate the electroforming process is a precise and efficient model and can be used for parametric studies. Finally, after parametric study, it was determined that all selected variables had a significant effect on the thickness uniformity. In addition, it was found that the most to least significant variables were applied current density, solution conductivity, anode-cathode spacing, and anode length, respectively.
Keywords:
Language:
Persian
Published:
Journal of Iranian Metallurgical and Materials Engineering Society, Volume:21 Issue: 71, 2018
Pages:
198 to 206
https://www.magiran.com/p1937377
سامانه نویسندگان
مقالات دیگری از این نویسنده (گان)
-
Numerical analysis of shaped charge jet penetration into discrete concrete targets using LS-DYNA and ANSYS-AUTODYN
, Ali Ramezani, Gholamhossain Liaghat, Hamid Fazeli *, Mohsen Rouhbakhsh, Mohammadamin Nabakhteh
Amirkabir Journal Mechanical Engineering, -
Prediction of Shrinkage Porosity and its Remedy by Numerical Simulation in a Conical Carbon Steel Casting
Asghar Heydari *, Gholamreza Karbasian, , Hamid Fazeli
Founding Research Journal,