Effect of strain hardening behavior of material on deformation characteristics of samples during equal channel angular pressing
Author(s):
Article Type:
Research/Original Article (دارای رتبه معتبر)
Abstract:
In the present study, the effect of srain hardening exponent os material on flow characteristics, strain and damage distribution in sample and the load requred for the execution of the deformation process was investigated using finite element simulation. Results showed that the corner gap is not formed during deformation of ideally plastic material and the amount of eauivalent strain is higher in the bottom side of sample compared with other regions. However, with increassing the work hardening exponent, the size of corner gap increases and the bottom side recieves less amount of strain. Also, damage factor in the sample of idealy plastic material is higher at the top side compared with other regions and the tensile stresses are aplliyed on this area. Whereas, in the strain hardened material the higher damage factor was observed at the lower half of the sample. Finally. it was concluded that the pressing force increases with increassing the work hardening exponent.
Keywords:
Language:
Persian
Published:
Journal of Iranian Metallurgical and Materials Engineering Society, Volume:22 Issue: 75, 2019
Pages:
215 to 224
https://www.magiran.com/p2147755
سامانه نویسندگان
مقالات دیگری از این نویسنده (گان)
-
Microstructure and mechanical properties of AA 2024/AA 7072/AA 2024 multilayer composites prepared by accumulative roll bonding
Hassan Ebrahimi Bavili, , Ali Fardi Ilkhchy *
Iranian Journal of Manufacturing Engineering, -
Finite element analysis of the Non-Equal Channel Angular Pressing (NECAP) with different die geometries
Ali Fardi Ilkhchy, *
Journal of Modeling and Simulation, Summer-Autumn 2021