Injector Geometrical Parameters Analysis in Side Injection for Thrust Vector Control and Injection Belt Design around a Nozzle

Message:
Article Type:
Research/Original Article (دارای رتبه معتبر)
Abstract:

This paper focuses on the design and analysis of an injector suitable for a liquid injection thrust vector control (LITVC) system. The LITVC system is used in flight systems to control and divert the thrust vector using the secondary fluid spraying method. For this purpose, various types of injectors were studied and categorized based on the geometry and operating conditions. The centrifugal single-base injector was selected as the design basis due to its uniform spraying, the ability to transfer higher flow rates, and relatively smaller geometric dimensions. In this process, in addition to defining three groups of non-dimensional geometric parameters, design was made based on engineering calculations and numerical solutions in FLUENT. The injector with proper outlet speed and the lowest pressure drop was selected as the final product of the design. Then, three different types of configurations were studied and the amount of thrust vector deflection created by each configuration was calculated. Findings were validated using the results reported by the previous researches, and finally, the best spray belt was introduced.

Language:
Persian
Published:
Journal of Energetic Materials, Volume:14 Issue: 4, 2020
Pages:
227 to 236
https://www.magiran.com/p2196922  
سامانه نویسندگان
  • Corresponding Author (1)
    Mohammadreza Heidari
    Professor Department of Mechanic, Parand Branch, Islamic Azad University, Parand, Iran
    Heidari، Mohammadreza
اطلاعات نویسنده(گان) توسط ایشان ثبت و تکمیل شده‌است. برای مشاهده مشخصات و فهرست همه مطالب، صفحه رزومه را ببینید.
مقالات دیگری از این نویسنده (گان)