Frontiers in Dentistry
Volume:12 Issue: 2, Feb 2015

Laser irradiation has been suggested as an adjunct to traditional caries prevention methods. But little is known about the cariostatic effect of diode laser and most studies available are on permanent teeth.The purpose of the present study was to investigate the effect of diode laser irradiation combined with topical fluoride on enamel surface microhardness. Forty-five primary teeth were used in this in vitro study. The teeth were sectioned to produce 90 slabs. The baseline Vickers microhardness number of each enamel surface was determined. The samples were randomly divided into 3 groups. Group 1: 5% NaF varnish, group 2: NaF varnish+ diode laser at 5 W power and group 3: NaF varnish+ diode laser at 7 W power. Then, the final microhardness number of each surface was again determined. The data were statistically analyzed by repeated measures ANOVA at 0.05 level of significance. In all 3 groups, microhardness number increased significantly after sur-face treatment (P˂0.05). However, Microhardness change after treatment was not significantly different among groups (P ˃0.05). The combined application of diode laser and topical fluoride varnish on enamel surface did not show any significant additional effect on enamel resis-tance to caries.

This in-vitro study sought to assess the push-out bond strength of a total etch and 2 self-etch bonding systems to intracanal dentin of primary anterior teeth (PAT). Thirty-six primary anterior teeth were randomly divided into 3 groups of 5th generation (Single Bond 2), 6th generation (Clearfil SE) and 7th generation (Single Bond Universal) bonding agents. The canal orifice was restored with composite resin and the push-out test was carried out to assess the bond strength. After applying the push-out load, specimens were evaluated under a light microscope at 40X magnification. One-way ANOVA and log-rank test on Kaplan-Meier curves were applied for the comparison of bond strength among the 3 groups. The mean± standard deviation (SD) bond strength was 13.6±5.33 MPa for Single Bond 2, 13.85±5.86 MPa for Clearfil SE and 12.28±5.24 MPa for Sin-gle Bond Universal. The differences in bond strength among the 3 groups were not statistically significant (P>0.05). All three bonding agents are recommended for use with composite posts in PAT. However, due to high technical sensitivity of the Total Etch system, single or two-step self etch systems may be preferred for uncooperative children.

The aim of this study was to introduce modified continuous wave compaction (MCWC) technique and compare its obturation quality with that of lateral compaction (LC), warm vertical compaction (WVC) and continuous wave compaction techniques (CWC). The obturation time was also compared among the four techniques. Sixty-four single-rooted teeth with 0-5° root canal curve and 64 artificially created root canals with 15° curves in acrylic blocks were evaluated. The teeth and acrylic specimens were each divided into four subgroups of 16 for testing the obturation quality of four techniques namely LC, WVC, CWC and MCWC. Canals were prepared using the Mtwo rotary system and filled with respect to their group allocation. Obturation time was recorded. On digital radiographs, the ratio of area of voids to the total area of filled canals was calculated using the Image J software. Adaptation of the filling materials to the canal walls was assessed at three cross-sections under a stereomicroscope (X30). Data were statistically analyzed using ANOVA, Tukey’s post hoc HSD test, the Kruskal Wallis test and t-test. No significant difference existed in adaptation of filling materials to canal walls among the four subgroups in teeth samples (P ≥ 0.139); but, in artificially created canals in acrylic blocks, the frequency of areas not adapted to the canal walls was significantly higher in LC technique compared to MCWC (P ≤ 0.02). The void areas were significantly more in the LC technique than in other techniques in teeth (P < 0.001). The longest obturation time belonged to WVC technique followed by LC, CW and MCWC techniques (P<0.05). The difference between the artificially created canals in blocks and teeth regarding the obturation time was not significant (P = 0.41). Within the limitations of this in vitro study, MCWC technique resulted in better adaptation of gutta-percha to canal walls than LC at all cross-sections with fewer voids and faster obturation time compared to other techniques.

Residual microorganisms in the root canal system (RCS) after endodontic therapy such as Candida albicans are a major cause of endodontic failure. Calcium hydroxide (CH) and chlorhexidine (CHX) have suitable antimicrobial activity against bacteria and can be used as intracanal medicaments. Nanosilver has also shown antimicrobial activity against microorganisms. This study aimed to compare the antifungal effect of calcium hydroxide, 2% chlorhexidine and nanosilver gels on Candida albicans. Eighty-one single-rooted teeth were selected. After root canal preparation, the teeth were contaminated. After culture, the teeth were randomly divided into 4 groups. In experimental groups, 24 teeth were selected and completely filled with CH, 2% CHX and nanosilver gels in each group. Nine teeth were selected in the control group and filled with saline solution. After 1, 3, and 7 days, samples were obtained by #30 sterile paper points, and #2 and #4 Gates Glidden drills and cultured on solid Sabouraud agar. The results demonstrated that CH and 2% CHX had equal antifungal effects on samples taken by paper point and #2 Gates Glidden drill at all time points. Both CH and 2% CHX were more effective than nanosilver at all time periods. There was no statistically significant difference between medicaments in samples taken by #4 Gates Glidden drill. CH and 2% CHX gels have significantly higher antifungal activity than nanosilver gel. Also, CH and 2% CHX gels are equally effective against Candida albicans.

Debonding is a common occurrence in orthodontic treatment and a considerable number of orthodontists prefer to rebond the detached brackets because of economic issues. The aim of this study was to compare the microleakage beneath rebonded stainless steel brackets using two methods of adhesive removal namely sandblast and laser. Sixty human premolar teeth were randomly divided into three groups. Following bonding the brackets, group 1 served as the control group. Brackets in groups 2 and 3 were debonded, and adhesive removal from the bracket bases was done by means of sandblasting and Er-YAG laser, respectively. After rebonding, teeth in each group were stained with 2% methylene blue for 24 hours, sectioned and examined under a stereomicroscope. Marginal microleakage at the adhesive-enamel and bracket-adhesive interfaces in the occlusal and gingival margins was determined. Statistical analysis was done using the Kruskal-Wallis test. Comparison of the microleakage scores among the three groups revealed no statistically significant difference (P > 0.05). At the enamel-adhesive interface, the gingival margins in all groups showed higher microleakage while in the adhesive-bracket interface, the occlusal margin exhibited greater microleakage. Er-YAG laser irradiation and sandblasting for adhesive removal from the debonded brackets yielded clinically acceptable microleakage scores.

The purpose of this ex- vivo study was to evaluate the fracture resistance of simulated immature teeth, obturated with Gutta-percha or Resilon and reinforced by either composite resin or fiber post. Eighty-four human maxillary incisors were divided into seven groups (n=12). Teeth in all groups were prepared until Peeso #5 (1.5mm) could be passed through the apex. Root ends received 4mm of MTA plug as an apical barrier. Groups received the followings: 1.Gutta-percha, 2.Resilon, 3.Gutta-percha + composite resin, 4.Resilon + composite resin, 5.Gutta-percha + fiber post, 6.Resilon + fiber post and 7.No obturation (control group). Access openings were filled with composite resin. Specimens were then subjected to oblique load using Instron Testing Machine. The mean peak load at fracture was recorded and analyzed using ANOVA. Experimental groups had a significantly more fracture resistance than the control group (P< 0.05). No significant difference was seen between experimental groups. Teeth reinforced by fiber post showed favorable fracture resistance. Treatment plans used in this study increase the fracture resistance of immature teeth. Use of fiber posts in immature teeth, may be the most favorable clinically applicable technique.

Cytotoxic effects of obturation materials were tested in presence and absence of endotoxin on human monocytes in vitro. Human monocytes from THP-1 cell line were cultured. Three millimeters from the tip of each Resilon and gutta percha points were cut and directly placed at the bottom of the culture wells. Cultured cells were exposed to gutta percha (groups G1 and G2) and Resilon (R1 and R2). Ten μg/ml bacterial lipopolysaccharide (LPS) was added to the culture wells in groups G1 and R1. Positive control included the bacterial LPS without the root canal filling material and the negative control contained the cells in culture medium only. Viability of cells was tested in all groups after 24, 48, and 72 hours using the methylthiazolyldiphenyl-tetrazolium bromide (MTT) assay for at least 3 times to obtain reproducible results. Optical density values were read and the data were analyzed using three-way ANOVA and post hoc statistical test. The results showed that cells in G2 had the lowest rate of viability at 24 hours, but the lowest rate of viable cells was recorded in G1 at 48 and 72 hours. The effect of LPS treatment was not statistically significant. Resilon groups showed cell viability values higher than those of gutta percha groups, although statistically non-significant (P=0.105). Cell viability values were lower in gutta percha than Resilon groups when LPS-treated and LPS-untreated groups were compared independently at each time point. It could be concluded that none of the tested root canal filling materials had toxic effects on cultured human monocyte cells whether in presence or absence of LPS contamination.

Controversy exists regarding cavity preparation for restoration of in-terproximal caries in posterior teeth in terms of preserving the tooth structure and suitable stress distribution. This study aimed to assess the effect of extension and type of class II cavities and the remaining tooth structure in maxillary premolars restored with composite resin on the biomechanical properties of teeth using finite element method (FEM). Using FEM, eight three-dimensional (3D) models of class II cavities in maxillary premolars with variable mesiodistal (MD) dimen-sions, variable thickness of the residual wall in-between the mesial and distal cavities and different locations of the wall were designed. Other dimensions were the same in all models. Cavities were restored with composite resin. A load equal to the masticatory force (200N) was applied to the teeth. Finite element analysis (FEA) was used to calculate the von Mises stress. Stress in the enamel margin increased by increasing the MD dimensions of the cavities. Deviation of the residual wall between the mesial and distal cavities from the tooth center was found to be an important factor in increasing stress concentration in the enamel. Increasing the MD dimensions of the cavity did not cause any increase in stress concentration in dentin. Increasing the MD dimensions of the cavities, decreasing the thickness of the residual wall between the mesial and distal cavities and its deviation from the tooth center can increase stress concentration in the enamel but not in dentin.

It has been claimed that periodontal dressing reduces the risk of wound infection, bleeding and granulation tissue formation and improves tissue healing. This study sought to assess the effect of periodontal dressing on wound healing and patient satisfaction following periodontal flap surgery. This clinical trial was conducted on 33 patients presenting to Hamadan University, School of Dentistry in 2012 whose treatment plan included two periodontal surgical procedures on both quadrants of the maxilla or mandible. The variables evaluated were severity of pain, bleeding, facial swelling and ease of nutrition experienced by patient during the first 3 days after surgery and inflammation, granulation tissue formation and gingival color at 7 and 14 days. Obtained data were analyzed using SPSS version 16.0 and R software and chi-square and t-tests. The mean (±SD) pain score was 1.73±1.153 and 2.79±1.933 in surgical sites with and without periodontal dressing, respectively and this difference was statistically significant (P=0.005). No significant difference was noted between sites with and without periodontal dressing in terms of swelling, bleeding, gingival consistency, granulation tissue formation, gingival color and ease of nutrition (P>0.05). According to the results of the present study, patients did not experience more bleeding, facial swelling or nutritional problems without periodontal dressing; however, the level of pain experienced was lower after surgeries with the use of periodontal dressing.

Central giant cell granuloma (CGCG) is a benign proliferation of fibroblasts and multinucleated giant cells that almost exclusively occurs within the jaws. It commonly occurs in young adults showing a female predilection in anterior mandible. Multifocal CGCGs in maxillofacial region are very rare and suggestive of systemic diseases such as hyperparathyroidism, an inherited syndrome such as Noonan-like multiple giant cell lesion syndrome or other disorders. Only 10 cases of multifocal CGCGs in maxillofacial region without any concomitant systemic diseases have been currently reported in English literature. We report here an unusual case of 36 year old female who presented with nonsyndromic synchronous, multifocal CGCGs in left posterior mandible and left posterior maxilla without any concomitant systemic disease. Literature regarding the same is reviewed and the incidence, clinical features, radiological features, differential diagnosis and management of CGCGs are discussed.