Shape Optimization of an Asymmetric Airfoil for Low Wind Speed Region having Adjoint-Based Optimization Technique

The land needed to install wind turbines is shrinking as power generation from renewable energy sources increases significantly. A large number of studies are being conducted to maximize the power extraction from wind turbines in areas with low wind speeds. Wind turbine blades play a significant role in utilizing the maximum amount of energy from the wind. The aerodynamic performance of a wind turbine blade depends on the airfoil shape. The shape optimization of an asymmetric S2027 airfoil for a low wind speed region was investigated using the adjoint-based optimization technique. The primary objectives of this study were to maximize the lift coefficient, minimize the drag coefficient, and maximize the lift-to-drag ratio. The optimization is based on the adjoint method for Reynolds number variation in the range of 2 × 105 to 5 × 105 and an angle of attack variation from 0° to 12°. A two-dimensional Reynolds–Averaged Navier–Strokes Computational Fluid Dynamics model was created with all the operating parameters and used for optimization. The aerodynamic performance was validated experimentally. For each optimization function, approximately 16 shapes were obtained. The aerodynamic performance for each optimized shape was determined under different operating conditions. Different airfoil shapes with a specific chord, leading and trailing edges, and span arrangement was obtained. The drag coefficient was reduced by 2%–30%; the lift coefficient was improved by 2%–35%, and the lift-to-drag ratio was improved up to 40%.