مجله دندانپزشکی دانشگاه علوم پزشکی تهران
سال بیست و چهارم شماره 3 (پیاپی 68، پاییز 1390)

Relative displacement of the implant with respect to bone and quality of bone-implant contact play critical roles in the dental implant stability. The goal of this study was to investigate the dental implant stability using non-linear finite elements method. Therefore, bone-implant relative displacement due to applied force to the implant was calculated, and then an appropriate factor for defining quality of bone-implant contact was presented. In order to develop a three dimensional model and compare the results with clinical studies, computed tomography (CT) scan data of a rabbit tibia was considered as a base. The model was exported to ABAQUS 6.9-1 to be analyzed using nonlinear finite elements method. Dynamic analysis was done on the model using the proper boundary condition and dynamic loads. Force-displacement curves in bone-implant interface were nonlinear. Friction coefficient, which is a criterion for implant stability and relative displacement, approximately became doubled as the vertical contact force was halved. However, the friction coefficient decreased with reduction of coulomb frictional coefficient. Friction coefficient, which is calculated upon force-displacement curves, could be considered as a criterion to evaluate the dental implant stability. Decrease of the vertical contact force and also using rough surfaces improved the quality of bone-implant contact and stability of dental implant.

Marginal seal in class V cavities and determining the best restorative material to decrease microleakage is of great importance in operative dentistry. The aim of this study was to evaluate the effect of polishing time on the microleakage of three types of tooth-colored restorative materials in class V cavity preparations and to assess the marginal integrity of these materials using scanning electron microscope (SEM). In this in vitro study, class V cavity preparations were made on the buccal and lingual surfaces of 30 bovine incisors (60 cavities). The specimens were divided into three groups each containing 10 teeth (20 cavities): group 1, Filtek Z350 (nanocomposite); group 2, Fuji IX/G Coat Plus (CGIC); and group 3, Fuji II LC (RMGI). In each group, half of the specimens (n = 20) were finished/polished immediately and the rest of them were finished/polished after 24 hours. All the specimens were thermocycled for 2000 cycles (5-50 °C). Epoxy resin replicas of 12 specimens (2 restorations in each subgroup) were evaluated using SEM and the interfacial gaps were measured. Finally, the teeth were immersed in 0.5% basic fuchsin dye for 24 hours at room temperature, sectioned and observed under stereomicroscope. The data were analyzed using Kruskal-Wallis and Mann-Whitney U tests and the comparison between incisal and cervical microleakage was made with Wilcoxon test. Incisal and cervical microleakage were not affected by polishing time in none of the three restorative materials (P>0.05). Cervical microleakage only in Fuji IX with immediate polishing was significantly higher than incisal microleakage (P<0.05). Incisal and cervical microleakage with immediate or delayed polishing were not significantly different in Fuji IX, Fuji II LC, and Z350 (P>0.05). Immediate polishing is recommended in tooth-colored class V restorations.

Instrumentation of the root canals results in formation of smear layer which covers the dentinal tubules. In infected teeth, it is ideal to achieve a material that has the ability to remove the smear layer besides antimicrobial activity. Therefore, this study was designed to evaluate the antimicrobial effect of Citrus aurantifolia extracts (lime juice and rind extract) on Enterococcus faecalis within dentinal tubules in the presence of smear layer. One-hundred and forty dentin tubes were prepared from bovine incisors. After removal the smear layer, the specimens were infected with Enterococcus faecalis. Then, the smear layer was reformed. Test solutions were used as the irrigants in study roups as follows: group 1: 5.25% NaOCl; group 2: 17% EDTA; group 3: NaOCl+EDTA; group 4: Lime juice; group 5: ethanolic rind extract of C.aurantifolia; group 6: 96% ethanol. Dentin chips were collected from inner and outer layers of dentinal walls and optical density was measured. The data were analyzed using one-way ANOVA and Tamhane tests. In outer layer of dentin, the efficacy of rind extract was less than that of NaOCl+EDTA (P<0.05). Also Lime juice was less effective than EDTA, NaOCl and NaOCl+EDTA (P<0.05). In inner layer of dentin, Lime juice was significantly less effective than NaOCl and NaOCl+EDTA (P<0.05). The efficacy of rind extract was less than that of NaOCl+EDTA (P<0.05). In the presence of smear layer, the antimicrobial activity of Lime juice was less than that of NaOCl but the efficacy of rind extract was similar to that of NaOCl.

Lasers with different characteristics have been used to stimulate orthodontic tooth movement. Considering the contradictory findings in this regard, this study was designed to assess the effect of low level laser therapy (LLLT) on the rate of orthodontic tooth movement. In this randomized clinical trial study, 12 patients (4 boys and 8 girls; average age:16.9 ± 3.4) with extracted upper first premolars and required canine retraction into extraction site were included. While in both sides canines were retracted by NiTi coil spring, one side was exposed to GaAlAs laser (890 nm). LLLT was done (on the buccal and palatal mucosa by slow movement of probe) at the beginning of the first month. Impression and cast fabrication performed at the beginning of retraction, one and two months later. The amount of retraction on the cast was measured with the aid of a reference plaque fabricated on the rogae using a digital caliper. Data were analyzed using paired sample T-test and one-sample Kolmogorov-Simirnov test. There was no significant difference in the amounts of canine movement between laser exposed and control sides (P>0.05). The energy dose of laser used in this study (72 J per each tooth) was not appropriate for increasing dental movement.

The bond strength between veneer ceramics and zirconia frameworks is the weakest component in the layered ceramics. Due to the possible effect of adding pigments to the core materials on the bond strength between core and veneer as well as the introduction of new ceramic materials in dentistry, the aim of this study was to compare the zirconia core-veneer microtensile bond strength using two ceramic veneers with or without coloring the core. In this experimental study, 12 disc-shaped specimens were fabricated using a manually aided design- manually aided manufactured (MAD/MAM) zirconia core (Zirkonzahn). Two veneering ceramics of Ceram Kiss and Zirkonzahn ICE were also used to veneer the specimens. Half of the Zirkonzahn discs were remained white and the others were colored by shade A2.Then, the discs were cut into microbars (30 for each group) and the microtensile bond strength of the core-veneer was calculated. The specimens were assessed using scanning electron microscopy (SEM) and the data were analyzed using two-way ANOVA and Student's t-test. Significant differences with respect to veneer layer were found (P<0.001). No significant differences were seen among colored and uncolored cores (P=0.69). According to the apparent effect of veneering ceramics on the core-veneer bond strength, careful selection of these agents is essential to achieve adequate bond strength between core and veneer to prevent delaminating and chipping failures of zirconia veneered restorations.

Non-steroidal anti-inflammatory drugs (NSAIDs) are the most common drugs prescribed for controlling and post root canal treatment pain. During the last decade, a new generation of NSAIDs has been introduced such as Celecoxib and Gelofen with less gastrointestinal side effects and more analgesic effect. No studies have been performed to compare Celecoxib and Gelofen with other NSAIDs considering the reduction of post-endodontic pain; therefore, this study was designed. In this randomized double blind clinical trial study, 90 patients were divided into 3 groups and underwent root canal therapy. Celecoxib, Gelofen, or placebo was randomized prescribed to the patients 1 hour before treatment. The intensity of pain was recorded using visual analog scale (VAS) at 4, 8, 12, 24, 48 hours after completion of root canal treatment. The data were analyzed by means of repeated measurements, multiple comparisons and one-way ANOVA tests using SPSS software. P<0.05 was considered as the level of significance. The results showed significant difference between Celecoxib and Gelofen in comparison with placebo at 8 and 12 hours after initiation of treatment. There was no significant difference among three groups at 4, 24, and 48 hours after initiation of treatment. According to the results, use of Gelofen or Celecoxib before treatment reduces post-endodontic pain. These drugs can be prescribed before initiation of treatment as the effective agents for reduction of post-endodontic pain

The evaluation of absorbed dose received by patients could give useful information for radiation risk estimation. This study was performed to compare the entrance skin dose received by patients in cone beam computed tomography (CBCT), conventional and spiral computed tomography (CT). In this experimental study, 81 calibrated TLD chips were used. the TLD chips were placed on facial, thyroid and end of sternum skin surface in patients referred for CT of the paranasal sinuses(3 TLD chips for each area) to estimate the absorbed dose received by central part of radiation field, thyroid and out of field areas, respectively. The data were analyzed using one-way ANOVA and Tukey tests. The dose delivered to the center of irradiated field was about 0.79±0.09 mGy in CBCT technique compared with 16.31±3.71 and 18.84±4.12 mGy for spiral and conventional CT, respectively. The received dose by the out of field areas was about 54 percent of central area dose. There was statistical significant relationship between the imaging modalities and absorbed dose received by patients (P=0.016). The least absorbed dose was for CBCT and the greatest dose was for conventional CT imaging technique. The dose delivered to central area of irradiated field in conventional and spiral CT imaging modalities was about 24 times greater than of that in CBCT. Also, the highest received dose was for central area of radiated field and the lowest dose was for the out of field areas.

Nowadays, calcium hydroxide is used as a dressing for canal sterilization and repair progression of apical lesions. The aim of this study was to investigate the effect of calcium hydroxide as an intracanal medicament on the apical microleakage of root filling. In this experimental study, 46 extracted single-rooted human teeth were instrumented with step-back technique to master apical file (MAF) size 35. Specimens were randomly divided into 2 groups (n = 20). In group 1, the specimens were treated with calcium hydroxide intracanal medication; and in group 2, the samples did not receive any medication. The teeth were incubated in 100% humidity at 37°C for one week. After that, calcium hydroxide was removed using irrigation with normal saline and reaming with MAF. The root canals were obturated with gutta- percha and AH26 sealer using lateral compaction technique. Specimens were incubated in 100% humility at 37°C for 72 hours and then immersed in India ink for 1 week. Finally, the teeth were cleared and the maximum linear dye penetration was measured under a stereomicroscope at 4X magnification. The data were analyzed by T-test and Chi-square. There was no significant difference between the two experimental groups (P=0.068). The findings of this study indicated that using calcium hydroxide as an intracanal medicament did not influence the apical microleakage after final obturation of the root canal system.